Skip to Content

Arc Reactor Cut File

Plan a fun Avengers Halloween Party with Halloween costume supplies and a little DIY!

Avengers Party

I promised to share how to make my arc reactor chip bowl ages ago. I suppose better late than never is the case here, right?

It’s pretty straight forward. You just need a red, plastic chip bowl. Cut out a hole the same size as a small tap light. If you have a hole cutter for your drill that’s the right size, this will be very easy. If you don’t, just cut it with a craft knife. (That was the route I took.) Use duct tape to hold the light in place from the inside of the bowl.

chip bowlThen grab my cut file and use your Silhouette to cut out the top of the arc reactor. I used black glossy paper for this and attached it to my chip bowl with my glue dot runner. The whole project-including cutting-takes less than 10 minutes!

Make sure you check out all of my fun Disney, Marvel and Star Wars Halloween ideas!

Disney Halloween Projects Hero

As The Bunny Hops®